Filter
Top Products
11
Canceling a Cycle
You can cancel a cycle at any time.
1.
Turn the cycle control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2.
Open the door.
3.
Turn the cycle control knob to Off.
Changing a Cycle or Setting
You can change a cycle anytime during a cycle.
1.
Lift the door latch to stop the cycle.
2.
Turn the cycle control knob clockwise.
3.
Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE:
Turning the cycle control knob can cause the covered
detergent dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4.
Close the door firmly until it latches. The dishwasher starts a
new cycle.
Adding Items During a Cycle
You can add an item anytime before the main wash starts, or the
cycle control knob reaches Normal Wash.
1.
Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2.
Open the door and add the item.
3.
Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4.
Close the door firmly until it latches. The dishwasher resumes
the cycle.
Option Selections
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Energy Saver Dry
Select this option to dry dishes without heat and save energy.
The dishes take longer to dry and some spotting can occur.
For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE:
Energy Saver Dry is an option with all cycles except Rinse
& Hold.
Heated Dry
Select this option to dry dishes with heated air. For best drying
results, use a liquid rinse aid and heated drying.
NOTE:
Heated Dry is an option with all cycles except Rinse &
Hold.
Plate Warmer (on some models)
Use the Plate Warmer cycle to warm serving dishes or dinner
plates.
NOTE:
Use the heated drying option with the Plate Warmer.
1.
Close and latch the door.
2.
Turn the cycle control knob to Plate Warmer.
3.
Allow 8 minutes for the cycle to heat the dishware.
4.
Press HEAT DRY.
Drying System
During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT:
The vapor is hot. Do not touch the vent
during drying.
Wash Rinse Rinse Main
Wash
Rinse Final
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
● ●
20 2.9/10.9
Use this cycle for rinsing
dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent
with this
cycle.
RINSE
& HOLD