Roper RUD5000 Dishwasher User Manual


 
12
Canceling a Cycle
You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you hear
water draining. Let the dishwasher drain completely.
2. Open the door.
3. Turn the Cycle Control knob to OFF.
Changing a Cycle or Setting
If your dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
2. Turn the Cycle Control knob clockwise.
3. Check the detergent dispensers. They must be filled properly
for the new cycle.
NOTE: Turning the Cycle Control knob can cause the covered
Detergent Dispenser section to open and release the
detergent. Check the covered section if the cycle uses
detergent in both sections.
4. Close the door firmly until it latches. The dishwasher starts a
new cycle.
Adding Items During a Cycle
You can add an item anytime before the main wash starts, or the
Cycle Control knob reaches Light Wash.
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door and add the item.
3. Close the door, but do not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the door firmly until it latches. The dishwasher resumes
the cycle.
Option Selections
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Energy Saver Dry
Select this option to dry dishes without heat and save energy.
The dishes take longer to dry and some spotting can occur.
For best drying, use a liquid rinse aid. Some items (such as
plastics) may need towel drying.
NOTE: Energy Saver Dry is an option with all cycles except Rinse
& Hold (on some models).
Heated Dry
Select this option to dry dishes with heated air. For best drying
results, use a liquid rinse aid and heated drying.
NOTE: Heated Dry is an option with all cycles except Rinse &
Hold (on some models).
For Model 5750: To select Heated Dry, press RESET OPTIONS.
Low Energy Washing (model 5750 only)
Select this low energy washing option to reduce water
temperature during the main wash and final rinse. This will reduce
the amount of electricity needed to run the dishwasher.
NOTE:
Low Energy Washing (model 5750 only) is an option
with all cycles.
Reset Options (model 5750 only)
Select this option to change an option setting.
You can change option settings anytime during a cycle as long as
the cycle has not passed the point where the option is used. For
example, you can press Energy Saver Dry anytime before the
Cycle Control knob reaches Dry.
1. Press RESET OPTIONS.
2. Press 1 or more options.
Wash Rinse Rinse Main
Wash
Rinse Final
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
●●
●●
●●
●●
85 5.7/21.8
Wash Rinse Rinse Main
Wash
Rinse Final
Rinse
Dry Time
(min)
Water
Usage
(gal/L)
●●
20 2.9/10.9
Use this cycle for pre-
rinsed or lightly soiled
loads.
Use
covered
detergent
dispenser
section.
LIGHT
WASH
Use this cycle for rinsing
dishes, glasses, and
silverware that will not be
washed right away.
Do not use
detergent
with this
cycle.
RINSE
& HOLD
OR
OR