Filter
Top Products
5
single cup – again?
35 You used the dispenser instead of the kettle, now you want another single cup?
36 No problem – wait till the reservoir refills (3 seconds if the kettle’s cold, 15 seconds if
it’s hot).
37 Go back to point 22 on the opposite page.
general
38 When you lift the kettle, you may see moisture on the stand. Don’t worry – it’s the
steam used to switch the kettle off automatically, which then condenses and
escapes via vents under the kettle.
39 Don’t worry about discolouration on the floor of the kettle. It’s due to the bonding
of the element to the kettle floor.
40 Don’t try to boil the kettle and the dispenser at the same time. Using both elements
would overload the power socket, so we’ve interlocked the switches, so if you do
this accidentally, the dispenser will override the kettle.
41 If you leave the dispenser unused for a few days, fill the kettle with fresh water, boil
off the water in the dispenser reservoir into a 240ml cup, and pour it away, as the
water will be stale. The stale water won’t do you any harm, as it’ll have been boiled
by the time it reaches the cup, but it’ll probably affect the taste of your drink.
using with insufficient water
42 This will shorten the life of the elements.
43 A boil-dry cut-out will switch the element off.
44 To prevent it cycling on and off, unplug the stand (switch the socket off first, if it’s
switchable), and leave it till it gets cold.
45 Don’t fill the kettle till it’s cold, or it may spit.
care and maintenance
1 Check that the kettle and dispenser switches are off – press 0 on both switches.
2 Unplug the stand (switch the socket off first, if it’s switchable), and let the kettle and
stand cool down fully.
3 Remove the kettle from the stand, wipe it, inside and out, with a damp cloth. You
may use a little household detergent, but if you do, rinse well to avoid tainting the
water.
4 Put a finger in the hollow by the side of the cover, lift the cover off, and wipe it with
a damp cloth.
5 Pull the drip tray gently out of the stand, empty it, then wipe it, inside and out, with
a damp cloth.
6 Wipe the surfaces of the stand with a damp cloth.
7 Replace the drip tray, the cover, then the kettle on the stand.
8 Keep all connectors and sockets dry.
9 Don’t put the kettle or stand in liquid.
10 Don’t use harsh or abrasive cleaning agents or solvents.
11 Don’t put any part of the appliance in a dishwasher.