Filter
Top Products
• 9 •
Orange
Green
Green
Green
Red
Using the machine for the
first time or after a long
period of inactivity.
These simple operations will make it pos-
sible to always brew excellent co ee.
1 Place a large container under the
dispensing spout.
2 Before starting the procedure, check
that the following icon is displayed.
3 Select the pre-ground co ee function
by pressing the “
“ button one or
more times.
Do not add the pre-ground
co ee to the compartment.
The icon will appear on the display.
4 Press the button to brew a long cof-
fee.
5 Wait until brewing is completed and
empty the water tank.
6 Repeat the operations from step 1 to
step 5 for 3 times; then continue with
step 7.
7 Place a container under the steam wand
(Pannarello, if supplied).
8 Turn the selector dial clockwise to set it
to the “
” position.
The following icon will be displayed.
9 Dispense water until the no water
signal is displayed, then turn the se-
lector dial counter-clockwise to set it
to the “
” position.
10 At the end, fill the water tank again.
Then the products can be brewed as
described in the following sections.
Rinse/Self-Cleaning Cycle
This cycle will rinse coffee circuits with
fresh water.
The cycle is carried out:
• At machine start (with cold boiler)
• After priming the water circuit (with
cold boiler)
• During the stand-by mode (if a co ee
product has been brewed)
• If the machine is turned o by pressing
the ON/OFF button (if a co ee product
has been brewed).
A small amount of water will be dis-
pensed to rinse and heat all the machine
components; in this phase this icon is
displayed:
Wait for the cycle to nish automatically.
You can stop dispensing as well, by
pressing either co ee button and/or
the ON/OFF button.