Filter
Top Products
OPERATING INSTRUCTIONS
1To open, hold the unit vertically, gripping the cover in one hand, and
the grinder in the other.
2Turn the cover to move the pointer from to .
3 Gently lift the cover off.
INSTALL BATTERIES FOR OPERATION
1 Fit 4 AA Alkaline batteries into the motor unit.
2 The polarities (+ and -) are marked on the battery compartment.
FILL THE GRINDER
1 Lift the motor unit off the grinder.
2 Fill the grinder with peppercorns, sea salt, dried herbs or spices.
3 Don't overfill, or it won't fit together.
4 Align the pointers on the bottom of the motor unit with
the padlocks on the top of the grinder, and lower the motor
unit on to the grinder.
5 The spindle should slide easily into the centre of the motor unit.
6 Lower the cover on to the motor unit.
7 Align the pointer on the cover with the open padlock ,
push the cover down, then turn it to align the pointer with the
closed padlock .
ADJUST THE GRINDER
1Turn the whole mill upside down, and turn the knob right (-) until it
won't go any further.
2 Now turn it left (+) a little.
3Turn the mill right way up, and press and release the switch.
4 Check the grind size, and adjust till it's the way you want it.
5 Don't turn it more than 6 complete turns towards +, or you may
unscrew the knob from the spindle.
6 Set the base down and sit the mill on the base.
GETTING TO KNOW YOUR
SALTON AUTOMATIC
SALT/PEPPER MILL
Your product may vary slightly
from illustration.
IMPORTANT SAFEGUARDS
When using this appliance, basic safety precautions should always be
followed including the following:
READ ALL INSTRUCTIONS BEFORE USING
1 Do not immerse the unit in water or any liquid.
2 Do not mix old and new batteries.
3Avoid contacting moving parts.
4 The use of attachments not recommended or sold by the manufacturer
may cause injury.
5 Remove the batteries and store in a dry, cool place when not in use.
6 Don't run the motor for more than 1 minute, or it may overheat. After
1 minute, switch off for at least 3 minutes, to let the motor cool.
7 Don't use the appliance for any purposes other than those described in
these instructions.
8 Don't run the appliance empty, it may overheat.
9 Don't use the appliance if it's damaged or malfunctions.
SAVE THESE INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE ONLY.
THIS IS NOT A TOY
CARE AND MAINTENANCE
Wipe the outside of the mills with a clean dry cloth. Don't let them get
wet or damp, and don't use detergent.
BATTERY CARE
1 Check that the batteries are fitted correctly - there's a guide inside the
battery compartment.
2 Don't leave dead batteries in the appliance, they may leak over
the product and surroundings.
3 Unless you're using the batteries regularly, it's best to remove
them altogether.
4 When you need new batteries, change them all. Don't use new and used
batteries together.
5 Don't use different kinds of batteries together.
6 Don't put old batteries in a fire or incinerator.
7 Don't try to recharge batteries unless they're specifically designed to
be recharged.
1
2
Cover P/N 71203
Motor Unit P/N 71204
Grinder P/N 71205
Base P/N 71206
Salton_SG8SS_IB_19-5-06 5/19/06 3:30 PM Page 3