Filter
Top Products
6
coffee in mill/brew basket per every two cups of coffee desired.
Replace lid. Make sure basket is firmly seated in assembly, lid on
basket is secured and lid to assembly is closed before
attempting to operate unit.
NOTE: You may substitute ground coffee for coffee beans by
turning off the mill. To do so, push the Mill button. The light will
come on. Place ground coffee into mill/brew basket. Use
approximately 1 tablespoon of grounds per cup of coffee.
4. You are now ready to initiate the automatic mill and brew process.
(If you wish to use the delay timer so you can program the
coffeemaker to mill and brew later, please read section entitled
“Programming the Timer” to make coffee later.
Programming the Mill
CAUTION: DO NOT OPEN UNTIL BLADES STOP AND BREWING
IS COMPLETE. CLEAN AND DRY ALL PARTS AFTER EACH USE.
If you desire a medium grind, your machine is automatically preset to
“4” or medium grind; refer to step 2 below. If you wish to program a
finer or coarser grind, start with step 1.
1. To set the mill to grind your beans to the desired level of
coarseness, press SELECT button to select different coarseness
levels, 1-7. Seven levels of coarseness are available.
Coarseness is determined by length of time milled—the longer
the time, the finer the grind. Setting 1 will mill the beans for
15 seconds. Setting 7 will mill the beans for 40 seconds. For
medium grind, try setting 4 (if you do not select a setting, the unit
will automatically default to setting 4). Make sure mill light is off.
2. Press ON button to initiate the mill/brew process; the red ON
light will come on. Mill will start. After mill stops, unit will
automatically switch to brewing operation. To interrupt milling
or brewing, press OFF button. Red ON light will then turn off.
Do not attempt to lift mill/brew lid until operation has come to
a complete stop.
3. After brewing is complete, remove decanter from warming plate
and serve. Coffeemaker warming plate will cycle on and off to
maintain proper coffee temperature for one hour before it
automatically shuts off and the red ON light turns off.
4. Unplug and allow unit to cool for 10 minutes between cycles.
Allow to cool completely before attempting to clean.
Brewing Instructions (Continued)