Salton MEPE123WTCAN Espresso Maker User Manual


 
13
For Best Results
Be sure to refrigerate your coffee pods to retain the robust flavor
and rich aroma.
The quality of water you use directly affects the taste of your coffee.
The better the water, the better the coffee. Always use fresh water.
Clean the parts as described in Care and Cleaning Instructions peri-
odically to ensure the freshest tasting espresso.
Always use fresh, cold skim milk or 2% milk when frothing. This will
result in wonderful froth. (Never use whole milk, cream, or half-and-
half.)
Chill your frothing pitcher in the refrigerator before making froth.
Make sure the frothing pitcher is metal or ceramic, never glass.
Clean the Steam Nozzle and Frothing Attachment after each use
with a damp cloth or sponge.
To flavor cappuccino either with mocha or with flavored syrups such
as vanilla or almond, add them directly to the brewed coffee —
NEVER TO THE COFFEE MACHINE. Add syrup to the coffee
before adding froth.
ORDER MORE PODS TODAY! Call 1-800-233-9054.
Trouble Shooting
THE COFFEE IS NOT HOT ENOUGH
Pre-heat the cups, wait until the Green “GO” Control Light goes on.
This indicates the machine is hot enough for proper brewing.
NO COFFEE WILL COME OUT
Check the water level and make sure the valve under the water
reservoir is open by pressing the top of the reservoir.
THE MACHINE WON’T TURN ON
Check to make sure the Hood is completely closed and that the unit is
plugged in.
THE PUMP MAKES A LOT OF NOISE
Check the level of the water.
TO PURCHASE ADDITIONAL PODS & REPLACEMENT PARTS:
Call 1-800-233-9054 Monday - Friday 9am - 5pm CST
or, Order via the Internet: www.salton-maxim.com
Care and Cleaning Instructions (continued)
5. If Steam Nozzle seems blocked, see Purging Instructions.
6. If it is necessary to wash the Infusion System, please use the
following steps:
a. Open the Hood.
b. Unlock the Infusion System by turning the lock counter-
clockwise.
c. Pull the Infusion System out gently.
d. Rinse the Infusion System with water.
e. Re-assemble the Infusion System gently.
f. Turn the lock clockwise.
g. Close the Hood.
NOTE: This unit will not work correctly if the Hood is not closed
properly.
Any servicing requiring disassembly other than the above
cleaning must be performed by an authorized service center.
Purging Instructions
If you have made several consecutive cups and frothed/steamed milk,
carefully use the following steps to purge the steam nozzle.
CAUTION: STEAM IS HOT. AVOID CONTACT WITH HOT STEAM.
1. Turn machine to OFF position. Plug into a 120V ~ 60 Hz outlet.
2. Empty water from the Detachable Water Tank and place back into
position.
3. Slide Froth Attachment into position with pressure relief hole
turned facing the machine.
4. Turn machine to ON position.
5. Turn Temperature Switch to the “STEAM/FROTH” position.
6. Swivel the Frothing Attachment inward, toward the machine and
place a dry paper towel under the Frothing Attachment.
7. When the machine has heated to the correct temperature and the
Green GO Light is illuminated, turn the Function Selector
from “NEUTRAL” to the “STEAM/FROTH” position. Avoid
contact with steam.
8. Steam will be pushed through the Steam Nozzle to help clean it.
After 5 seconds, turn Function Selector to “NEUTRAL”
position.
12