Filter
Top Products
11
REFRIGERATOR INSTALLATION
REFRIGERATOR DOOR REMOVAL
If the refrigerator is too large to pass through your
doorway easily, you can remove the refrigerator doors.
1. After removing the screw, and carefully lift up the upper
right hinge cover.
Right Hinge Cover
2. Disconnect the reed switch connector from the hinge
cover and remove the hinge cover. Disconnect the hous-
ing connector from the electric wire harness in the top of
the refrigerator door. The third wire does not connect to
anything.
3. Remove the screw that holds the ground wire.
Ground Wire
4. With the 13/32-in. (10-mm) wrench, remove the three
bolts that hold the hinge on the top of the refrigerator.
5. Separate the hinge from the electric wire harness and
the ground wire.
6. Remove the refrigerator door by lifting it upward.
WARNING
Be careful not to drop the refrigerator door during
removal. Scratches or door damage could occur.
ENGLISH
Hinge Cover
Reed Switch Connector
Housing Connector
Unused Wire
DA99-01921A (EN-1).indd 11 2010.3.16 1:7:23 PM