Samsung C139STF Microwave Oven User Manual


 
10
GB
What to Do if You are in Doubt or You have a Problem
Becoming familiar with a new appliance always takes a little time. If
you have any of the problems listed below, try the solutions given. They
maysaveyouthetimeandinconvenienceofanunnecessaryservice
call.
The following are normal occurrences.
Condensation inside the oven
Air flow around the door and outer casing
Light reflection around the door and outer casing
Steam escaping from around the door or vents
The food is not cooked at all
Have you set the timer correctly and pressed the Start ( ) button?
Is the door closed?
Have you overloaded the electric circuit and caused a fuse to blow or a
breaker to be triggered.
The food is either overcooked or undercooked
Was the appropriate cooking length set for the type of food?
Was an appropriate power level chosen?
Sparking and cracking occur inside the oven (arcing)
Have you used a dish with metal trimmings?
Have you left a fork or other metal utensil inside the oven?
Is aluminium foil too close to the inside walls?
The oven causes interference with radios or televisions
Slight interference may be observed on televisions or radios when the
oven is operating. This is normal.
* Solution: Install the oven away from televisions, radios and aerials.
If interference is detected by the oven’s microprocessor, the display may
be reset.
* Solution: Disconnect the power plug and reconnect it. Reset the time.
“3" message indicates
The "E3" message is automatically activated prior to the microwave oven
overheating. Should the "E3" message be activated, then depress the
" " key to utilize the initialization mode.
If the above guidelines do not enable you to solve the problem, then
contact your local Samsung customer service centre.
Please have the following information read;
The model and serial numbers, normally printed on the rear
of the oven
Your warranty details
A clear description of the problem
Then contact your local dealer or SAMSUNG aftersales service.
C139ST_GB.fm Page 10 Wednesday, March 13, 2002 5:11 PM