Filter
Top Products
Operating the oven _29
04 OPERATING THE OVEN
EXTRA FEATURES
12 hour energy saving
With this feature, should you forget and leave the oven on, the control will automatically turn off
the oven after 12 hours during baking functions or after 3 hours during a broil function.
How to turn 12 hour energy saving feature on or off
1. Press COOKING TIME and 0 on the number pad at the same
time for 3 seconds. The default is 12 Hr.
The display will flash 12 Hr (12 hour shut-off) or -- Hr (no shut-off).
2. Press 0 on the number pad to select OFF or ON.
3. Press the SET/START pad.
Fahrenheit or Celsius temperature selection
The oven control can be programmed to display temperatures in Fahrenheit or Centigrade. The
oven has been preset at the factory to display in Fahrenheit.
How to change the display from Fahrenheit to Centigrade or from Centigrade
to Fahrenheit
1. Press BROIL and 0 on the number pad at the same time for 3
seconds. The default is F.
The display will flash F (Fahrenheit) or C (Centigrade).
2. Press 0 on the number pad changes the display between F and C.
3. Press the SET/START pad.
Thermostat adjustment
The temperature in the oven has been preset at the factory. When first using the oven, be sure to
follow recipe times and temperatures. If you think the oven is too hot or too cool, the temperature
in the oven can be adjusted. Before adjusting, test a recipe by using a temperature setting that is
higher or lower than the recommended temperature. The baking results should help you to decide
how much of an adjustment is needed.
The oven temperature can be adjusted ±35°F (±19°C ).
How to adjust the oven temperature
1. Press BAKE and 0 on the number pad at the same time for 3
seconds.
The display will show ADJ 0.
2. Enter the adjustment you want, eg. 20°F, by using the number
pad.
You can adjust the temperature to lower than the factory setting by
pressing the BAKE pad.
3. Press the SET/START pad.
This adjustment will not affect the broiling or the self-cleaning temperatures. The adjustment
will be retained in memory after a power failure.
FE-R400_XAC_DG68-00297A.indd 29 2010-03-23 5:47:18