Filter
Top Products
troubleshooting _23
troubleshooting
CHECK THESE POINTS IF YOUR DISHWASHER…
PROBLEM POSSIBLE CAUSE SOLUTION
Will not start.
The door is not closed completely. Check that the door is latched and
closed completely.
No cycle is selected. Select a cycle.
The power cable is not connected. Connect the power cable.
The water supply does not work. Check that the water supply valve is
open.
A circuit is tripped or a fuse is open. Reset the circuit breaker or replace
the fuse.
Is taking too long with an
operation (maybe cycle).
Cold water is being supplied. Check that the water supply line is
connected to a hot water supply.
(Additional time is required to heat
cold water.)
Has a bad odor.
There is water left over from the last
cycle.
Insert detergent without loading
dishes, and run the Quick cycle to
clean the dishwasher.
Has water remaining
after the cycle has
finished.
The drain hose is folded or clogged. Straighten the hose.
Has food particles
remaining on dishes.
An inappropriate cycle has been
selected.
Select a cycle according to the
number and soil level of the dishes,
as directed in this manual.
The water temperature is low. Connect the water supply line to a
hot water supply.
No dishwashing detergent is being
used.
Use a automatic dishwasher
detergent.
The pressure of the supplied water
is low.
The proper pressure of the supplied
water should be 20~120 psi
(140~830 kPa).
A nozzle is clogged. Clean the nozzle.
The dishes are improperly loaded. Rearrange the dishes so they do not
interfere with the nozzle rotation and
the dispenser operation.
Does not dry dishes well.
There is no rinse aid in the dispenser. Check the dispenser and add rinse
aid.
The temperature of the water is low
when the dishwasher is running.
Use rinse aid with the Sanitize
option.
05 troubleshooting