Samsung DMT400 Dishwasher User Manual


 
26_ troubleshooting
INFORMATION CODES
The Control Panel displays information codes to help you understand what is occurring with your
dishwasher. If you see any of the codes listed below, you should select the Cancel and Drain option, and
then follow the instructions in the Solution column.
If your dishwasher have any problem, below CODE SYMBOL light(s) is(are) blinked.
CODE SYMBOL MEANING SOLUTION
Temperature Sensor
error
Functional error. With the dishwasher empty, add
detergent, and then run a cycle.
If the problem continues, go to your house circuit
breaker panel, set the dishwasher’s circuit breaker
switch to off, and then contact an authorized
Samsung service center.
Heater error
High temperature
Heating error
Low-level water error
Water supply error
Check whether the water supply valve is closed, the
water supply is suspended or the water inlet valve or
line is frozen or clogged by foreign particles.
If the problem continues, close the water supply
valve, and then contact an authorized Samsung
service center.
High temperature
Water supply error
Check the temperature of the supplied water. If it
is higher than 176 ˚F (80 ˚C), a functional error may
occur with the dishwasher.
Drain error
Check whether the drain hose is clogged or folded. If
the problem continues, close the water supply valve,
and then contact an authorized Samsung service
center.
Over-level water error
Functional error. Close the water supply valve and
go to your house circuit breaker panel, set the
dishwasher’s circuit breaker switch to off, and then
contact an authorized Samsung service center.
Leakage error
Button error
Functional error. Turn off the dishwasher and try to
start it again.
If the problem continues, contact an authorized
Samsung service center.
For any codes not listed above, call 1-800-SAMSUNG (726-7864)
troubleshooting
DMT400_DD68-00074A.indb 26 2010-07-09 �� 11:28:34