Filter
Top Products
using your dishwasher _15
ADJUSTING THE HEIGHT OF THE UPPER RACK
You can adjust the height of the upper rack in your Samsung dishwasher so that the lower rack can
accommodate larger sized dishes. Depending on where you set the upper rack height, the lower rack can
accommodate plates up to 14 in. (36cm) in diameter and the upper rack can accommodated plates up to
12 in. (30cm) in diameter.
DMT800 Series
1. To lower the upper rack by 2 in. (5 cm), press
the ‘A’ levers located at the left and right
sides of the upper rack and push the upper
rack downwards slightly at the same time.
2. To raise the upper rack, just pull the upper
rack upwards without operating any levers.
The levers will latch and the upper rack will
move to the high position.
We recommend adjusting the height of the
upper rack before loading dishes into the
rack. If you adjust the the rack after loading
the dishes, you may damage the dishes.
REMOVING THE UPPER RACK
Pull the upper rack towards the front and then remove it by lifting it up slightly and pulling it towards the
front. See the illustrations below.
While the upper rack is removable, it must be installed for the dishwasher to operate properly.
If you attempt to operate the dishwasher without the rack, noise will occur and the dishwasher will
perform poorly.
Step 1. Step 2. Step 3.
Using the spread nozzle instead of the upper rack
You can use the extra spread nozzle instead of the upper
rack when you wash tall items such as oven’s tray in the
lower rack. Remove the upper rack, insert the extra spread
nozzle to the middle of duct nozzle, and load tall items in
the lower rack.
Insert the spread nozzle into the middle outlet of duct
nozzle and turn the spread nozzle clockwise to lock.
Refer to the illustration to the right.
02 using your dishwasher
CAUTION
CAUTION
A
1
2
DMT800_DD68-00050A.indb 15 2010-08-09 4:07:36