Samsung FE-R400SX Range User Manual


 
02 SURFACE COOKING
Surface cooking _17
Location of the radiant surface elements and controls
The radiant control knobs operate the radiant surface elements on the cooktop as shown below.
Single
Left Front
Eltnement
Single
Left Rear
Element
Single
Right Rear
Element
Dual
Right Front
Element
Warming Center
Center Rear
Element
Hot surface indicator
Comes on when the unit is turned on or hot to the touch.•
Stays on even after the unit is turned off.•
Glows until the unit is cooled to approximately 150°F.•
Cooking areas
The cooking areas on your range are identified by permanent circles on the glass cooking •
surface. For the most efficient cooking, fit the pan size to the element size.
Pans should not extend more than ½” to 1” beyond the cooking area.•
When a control is turned on, a glow can be seen through the glass cooking surface. • The
element will cycle on and off to maintain the preset heat setting, even at high settings.
For more information on selecting proper types of cookware, refer to the section “Using the •
proper cookware” on page 19.
Single surface unit control knob (left rear, right rear)
1. Push the knob in.
2. Turn in either direction to the setting you want.
At both the off and high settings, the knob clicks into position.•
Dual surface unit control knob (left front, right front)
The dual surface unit has 2 cooking sizes to select from so you can match
the size of the unit to the size of the cookware you are using.
1. Push the knob in.
2. Turn in either direction to the setting you want.
To use the small surface unit, turn the control knob to the small burner (A) •
settings.
To use the large surface unit, turn the control knob to the large burner (B) •
settings.
When changing from a high heat setting to a lower heat setting, the surface unit may stop
glowing. This is normal.
FE-R400_XAC_DG68-00297A.indd 17 2010-03-23  5:47:08