Samsung FE-R700 Range User Manual


 
60_ Troubleshooting
PROBLEM POSSIBLE CAUSE SOLUTION
Oven not clean after
a self-cleaning cycle
The oven controls were not set
correctly.
See the section on self-cleaning on page •
49.
The oven was heavily soiled. Wipe up heavy spillovers before starting •
the self-cleaning cycle. Heavily soiled
ovens may need to self-clean again or for
a longer period of time.
Steam from the vent When using the convection
feature, it is normal to see steam
coming out of the oven vent.
This is normal.•
As the number of racks or amount
of food being cooked increases,
the amount of visible steam will
increase.
Burning or oily odor
emitting from the
vent
This is normal in a new oven and
will disappear in time.
To speed the process, set a self-cleaning •
cycle for a minimum of 3 hours.
See the section on self-cleaning on page •
49.
Strong odor An odor from the insulation around
the inside of the oven is normal
for the first few times the oven is
used.
This is temporary.•
Fan noise A convection fan may automatically
turn on and off.
This is normal.•
Oven racks are
difficult to slide.
The shiny, silver-colored racks
were cleaned in a self-cleaning
cycle.
Apply a small amount of vegetable oil to •
a paper towel and wipe the edges of the
oven racks with the paper towel.
Display goes blank. A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit •
breaker.
Display flashes. There was a power failure. Reset the clock.•
Drawer does not
slide smoothly or
drags.
The drawer is out of alignment. Fully extend the drawer and push it all the •
way in. See the page 57.
The drawer is over-loaded or the
load is unbalanced.
Reduce weight. Redistribute drawer •
contents.
Warming drawer will
not work.
A fuse in your home may be blown
or the circuit breaker tripped.
Replace the fuse or reset the circuit •
breaker.
The controls are not set correctly. See the chapter on using the warming •
drawer on page 27.
Excessive
condensation in the
drawer
There is liquid present in the
drawer.
Remove the liquid.•
Uncovered foods. Cover food with a lid or aluminum foil.•
The temperature is set too high. Adjust the temperature to a lower setting.•
Food dries out in
the warming drawer.
Moisture is escaping. Cover food with a lid or aluminum foil.•
The drawer is not fully closed. Push the drawer in until the latch engages.•
FE-R700_XAC DG68-00294A.indb 60 2010-02-18 �� 11:36:22