Filter
Top Products
Setting Up _13
REMOVING THE REFRIGERATOR DOORS
SETTING UP THE REFRIGERATOR
Now that you have your new Refrigerator installed in place, you are ready to set up and enjoy the features and
functions of the appliance. By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location with reasonable clearance between the wall and the
Refrigerator. Refer to installation instructions in this manual. (P8. Selecting the best location for the
Refrigerator)
2. Once the Refrigerator is plugged in, make sure the interior light comes on when you open the doors.
3. Set the Temperature control to the coldest temperature and wait for an hour. The Freezer will get
slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few hours to reach the appropriate temperature. You can
store food and drinks in the Refrigerator after the temperature is sufficiently cool.
01 SETTING UP
Compression fitting
(DA62-00305A)
Compression nut
(DA74-00070B)
Phillips Head Driver(+) Flat Head Driver(-) Socket Wrench
(7/16inch) (for bolts)
Hex Wrench (3/16inch)
(for Mid hinge)
Hex wrench (5/32 inch)
(for Mid hinge shaft)
Required Tools (Not provided)
Some installations require door/drawer removal to transport the Refrigerator to its final location.
Do not remove the door/drawer if it is not needed. Before removing the door/drawer make sure you read
following items.
Disconnect power to the Refrigerator before remove door or drawer.
WARNING
• Be careful not to drop the door and door scratch and damage while removing the door/drawer.
• Be careful not to get injured while removing the door/drawer.
• After reattaching the door/drawer:
It is possible to have sweat by air leakage.
It is possible to have uneven door alignment.
It is possible to have more energy bills.
Check the accessories listed below.