Samsung RF260BEAESP Refrigerator User Manual


 
14_ operating
Reverse Osmosis Water Supply
IMPORTANT:
The pressure of the water supply coming out of a
reverse osmosis system going to the water inlet
valve of the refrigerator needs to be between 35
and 120 psi (241 and 827 kPa).
If a reverse osmosis water filtration system is
connected to your cold water supply, the water
pressure to the reverse osmosis system needs to
be a minimum of 40 to 60 psi (276 to 414 kPa.) If
the water pressure to the reverse osmosis system
is less than 40 to 60 psi (276 to 414 kPa):
Check to see whether the sediment filter in the
reverse osmosis system is blocked. Replace
the filter if necessary.
Allow the storage tank on the reverse osmosis
system to refill after heavy usage.
If your refrigerator has a water filter, it may
further reduce the water pressure when used
in conjunction with a reverse osmosis system.
Remove the water filter.
If you have questions about your water pressure,
call a licensed, qualified plumber.
CONTROLLING THE
TEMPERATURE
Basic temperature of Freezer and
Refrigerator Compartments
The basic temperature and recommended
temperatures of the Freezer and Refrigerator
Compartments are 0°F and 37°F(or -18°C and
3°C) respectively. If the temperature of the Freezer
and Refrigerator Compartments are too high or
low, adjust the temperature manually.
CONTROLLING THE
TEMPERATURE
Controlling the Freezer temperature
The Freezer temperature can be set between
8°F(-15°C) and -8°F(-23°C) to suit your particular
needs. Press the Freezer button repeatedly
until the desired temperature is shown in the
temperature display. Keep in mind that foods like
ice cream may melt at 4°F(-15°C).
The temperature display will move sequentially
from -8°F(-23°C) to 8°F(-15°C). When the display
reaches 8°F, it will begin again at -8°F(-23°C).
Five seconds after the new temperature is set, the
display will again show the actual current freezer
temperature until the new temperature is reached.
Controlling the Refrigerator
temperature
The Refrigerator temperature can be set between
44°F(7°C) and 34°F(1°C) to suit your particular
needs. Press the Fridge button repeatedly until the
desired temperature is shown in the temperature
display.
The temperature control process for the Fridge
works just like the Freezer process.
Press the Fridge button to set your desired
temperature. After a few seconds, the Fridge
will begin adjusting towards the newly set
temperature. This will be reflected in the digital
display.
The temperature of the Freezer or the
Refrigerator may rise from opening the
doors too frequently, or if a large amount of
warm or hot food is placed in either side.
This may cause the digital display to
blink. Once the Freezer and Refrigerator
temperature return to their normal set
temperatures, the blinking will stop.
If the blinking continues, you may need to
“reset” the Refrigerator. Try unplugging the
appliance, wait for around 10 minutes and
then plug the power cord back in.
DA68-02601B(EN+ES+FR)-0.0.indb 14 2012.3.29 9:28:43 AM