_19
operating
CAUTION
CAUTION
CAUTION
check the
water level
Test button
Fridge button to set your desired temperature.
After a few seconds, the Fridge will begin
adjusting towards the newly set temperature. This
will be reflected in the digital display.
The temperature of the Freezer, Fridge -
or Cool Select Pantry Zone may rise
when you open the doors too frequently,
or if a large amount of warm or hot food
is placed inside.
This may cause the digital display to blink. -
Once the Freezer and Fridge temperature
return to their normal set temperatures, the
blinking will stop.
If the blinking continues, you may need to -
“reset” the Refrigerator. Try unplugging the
appliance, wait for around 10 minutes and then
plug the power cord back in.
If there is a communication error between the -
Display and Main Controller, the Convertible
Display light may blink. If the blinking continues
for a long period of time, please contact a
Samsung Electronics Service Center.
USING THE COLD WATER
DISPENSER
Push the appropriate ice type
button to select what you want
dispensed.
Using the ice Dispenser
Maintaining the Ice Bucket
Place a glass underneath the ice
dispenser and push gently against the
dispenser lever with your glass.
Make sure the glass is in line with
the dispenser to prevent the ice from
bouncing out.
Please wait 2 seconds before removing the
glass under the dispenser to prevent spills.
If the Refrigerator door opens, the
Dispenser does not work.
When Cubed Ice is selected after using
the Crushed Ice mode, a small amount of
residual crushed ice might be produced.
Do not pull the lever out. You could damage
or break the lever’s spring.
To clean the ice bin/bucket, wash with a mild t
detergent, rinse well, and dry thoroughly it. Do
not use harsh or abrasive cleaners or solvents.
The ice cubes generated by the rapid ice t
making process will look white, which indicates
they are generated normally.
As the ice maker in the refrigerator room t
makes ice cubes even faster, move the ice
cubes from the refrigerator ice bin to the
freezer ice bin if you need more ice cubes.
If ice doesn’t come out, pull out the ice bucket t
and press the test button located on the right
side of ice maker.
Do not press the test button continuously t
when the tray is filled with ice or water. Water
may overflow or ice may jam the bucket.
Normal Use
t
To fill the ice bucket to maximum capacity after
installation, follow these steps:
Water may overflow or ice may jam the bucket.
NO ICE
Select this if you want to
Recommend Temp (Fridge) : 37°F (or 3°C )
DA68-02601A(EN+FR+ES)-0.2.indb 15 2012.3.31 9:49:48 AM
02 OPERATING