Filter
Top Products
08_ setting up
DISASSEMBLE THE FLEX DOOR
1. Take out the Flex
Zone ( 1 ) by lifting it
up.
2. Take off the cover
( 2 ) w/harness with a
fl at-blade screwdriver
(-).
3. Press the locking tab and separate the Wire
Connector.
When reassembling it, be sure to connect the
wire harness.
If it is not connected, the Flex Room does not
work.
4. Remove 2 hex head
bolts from sides with
a socket wrench
(10mm).
5. Lift up the Flex door from
the rails.
Putting too much food into the freezer
drawers can prevent the freezer from closing
completely and
can cause frost
build-up.
ASSEMBLE THE FLEX DOOR
To reattach the fl ex doors, assemble parts in reverse
order.
Be sure to connect the Flex Door Wire
Connector.
If it is not connected, the Flex Room does not
work.
DISASSEMBLE THE FREEZER
DRAWER
1. Take out the upper
drawer by lifting it up.
2. Remove the tilting pocket ( 1 ) by pulling both
support guards ( 2 ) aside. And take out both
support guards by pulling them aside.
3. Take out the lower
basket ( 3 ) by lifting
the basket up from
the rail system.
4. Remove 4 hex head bolts
from both sides with a
socket wrench (10mm).
5. Lift up the freezer door from
the rails.
1
2
1
2
3
CAUTION
CAUTION
CAUTION