Filter
Top Products
Setting Up _13
01 SETTING UP
5. Position the top table (
2
) in place. Insert and tighten
the 3 screws into the top table with a philips screw
driver(+). After door opened, reinsert the cap top table
(
1
) and close the doors.
When reattaching the top table, make sure that the
wires are not pressed or damaged by the hinge cover.
After assembling, close the door and check to see
whether the door has gaps between gaskets or is tilted.
If you see one of them, please refer to “Ad justing the
doors” page on 15.
1
2
REATTACHING THE REFRIGERATOR DOORS
The dispenser door tube (
5
) must be fully inserted to the marked line to
prevent water leakage from the dispenser.
CAUTION
3
3
4
5
4. Connect the dispenser door tube (
5
) and then
insert a clip on the coupler with pulling tube. Connect
the connector (
4
) on the left side door and two
connectors (
3
) at each side of the top cap.
The clip is enveloped inside of the top cap.
coupler
dispenserdoortube