Samsung RFG237AAWP Refrigerator User Manual


 
Operating _41
02 OPERATING
Ordering a Replacement Water Filter
For a replacement water filter, you can visit your local home improvement center or contact the Samsung Parts
distributor.
Be sure the replacement water filter has the SAMSUNG logo on the box and on the water filter.
Link: http://www.samsungparts.com
5. Lastly, Flush 3 gallons through filter before use (flush approximately 6 minutes) Make sure that
water flows clearly again before drinking.
Be sure to flush the dispenser thoroughly otherwise water may drip from the dispenser.
This means that there is still air in the line.
Do NOT use the water or ice dispenser without a water filter cartridge because the water line may become
blocked.
4. After above steps, press and hold the Alarm / Hold 3 sec for Filter Reset button for 3 seconds
to reset the filter.
CHANGING THE WATER FILTER
To reduce risk of water damage to your property DO NOT use generic brands of water filters in your
SAMSUNG Refrigerator. USE ONLY SAMSUNG BRAND WATER FILTERS.
SAMSUNG will not be legally responsible for any damage, including, but not limited to property damage
caused by water leakage from use of a generic water filter. SAMSUNG Refrigerators are designed to work
ONLY WITH SAMSUNG WATER Filter.
The “Filter” light lets you know when it is time to change your water filter cartridge. To
give you preparation time to get a new filter, the red light will come on just before the
capacity of the current filter runs out. Changing the filter on time provides you with the
freshest, cleanest water from your refrigerator.
1. Take a new water filter and put a month indicator sticker (
1
) on the filter as shown.
The date on the sticker must be six months from the current date. For example, if you are replacing
the water filter in March, put the “SEP” (September) sticker on the filter to remind you to replace in
September. Normal filter life is about 6 months.
2. Remove the new filter’s protective cap (
2
) and remove the old filter.
3. Position and insert the new filter into the cover filter.
Slowly turn the water filter clockwise to align with the printing mark on the cover, locking the filter in
position. Make sure to align the water filter label (
3
) mark with the center of cover filter printing as
illustrated. Remember, do not over-tighten.
Turn until the
label aligned.
Cover filter
Indicator sticker
(month indicator)
1
2
3
WARNING
DA68-01827B-15.indb 41 13. 4. 24. �� 11:31