Filter
Top Products
33
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
Connect the water line to the refrigerator.
Water line must be connected to drinkable water only.
Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnecting.
Do not overtighten the compression nut.
NOTE
NOTE
Compression Nut (1/4
(Provided)
Compression Fitting
(Provided)
Compression Nut (1/4
(Purchased)
Plastic Tubing
(Purchased)
Copper Tubing
(Purchased)
Ferrule
(Purchased)
Household Water Line
Refrigerator
1) Slip the compression nut through the provided
plastic tubing.
2) Tighten the compression nut onto the 1/4”
compression fitting.
3) Tighten the compression nut onto the com-
pression fitting.
4) Turn water on and check for any leakage.
Using Copper Tubing
- Slip the compression nut and ferrule on
copper tubing as shown.
Using Plastic Tubing
- Insert the molded end of the plastic tubing
into the compression fitting.
WARRANTY INFORMATION
This water line installation is not covered by the Samsung
refrigerator's warranty.
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorized service dealer and purchase
the right coupler fittings.
Check the water supply line
Connect the water line to the refrigerator.
Connect the water pipe with coupler and tap.
- Close the main water tap.
- Connect coupler “A” to the tap.
- Every joint should be protected with sealing tape.
(Case 2)
COUPLER “A”
TAP
CAUTION
The water line must be connected
to the cold water pipe.
If it is connected to the hot water
pipe, it may cause the
purifier to malfunction.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
CONNECTION NUT
COMPRESSOR COVER OF
REFRIGERATOR