Filter
Top Products
• In case of R600a refrigerant, this gas is natural gas with high environmental compatibility that is, however, also
combustible. When transporting and installing the appliance, care should be taken to ensure that no parts of the
refrigerating circuit are damaged.
• Refrigerant squirting out of the pipes could ignite or cause an eye injury. If a leak is detected, avoid any naked ames
or potential sources of ignition and air the room in which the appliance is standing for several minutes.
WARNING
• In order to avoid the creation of a ammable gas-air mixture if a leak in the refrigerating circuit occurs, the size of the
room in which the appliance may be sited depends on the amount of refrigerant used.
• Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.
• The room must be 1m
3
in size for every 8g of R600a refrigerant inside the appliance.
• The amount of refrigerant in your particular appliance is shown on the identication plate inside the appliance.
• Please dispose of the packaging material for this product in an environmentally friendly manner.
• Pull the power plug out of the socket before changing the interior light of the refrigerator.
- Otherwise, there is a risk of electric shock.
SEVERE WARNING SIGNS
WARNING
• Do not install the refrigerator in a damp place or place where it may come in contact with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
• Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.
• Allow sufcient space to install the refrigerator on a at surface.
- If your refrigerator is not level, the internal cooling system may not work correctly.
• Do not plug several appliances into the same power socket. The refrigerator should always be plugged into its own
individual electrical which has a voltage rating that matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits, which could cause a fire
hazard from overheated wires.
• Never unplug your refrigerator by pulling on the power cord. Always grip plug rmly and pull straight out from the
outlet.
- Damage to the cord may cause a short-circuit, fire and/or electric shock.
• Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
• Do not bend the power cord excessively or place heavy articles on it.
- This constitutes a re hazard.
• Have the power cord repaired or replaced immediately by the manufacturer or its service agent if power cord has
become frayed or damaged.
• Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• If the power cord is damaged, have it replaced immediately by the manufacturer or its service agent.
• When moving the refrigerator, be careful not to roll over or damage the power cord.
• Do not insert the power plug with wet hands.
• Unplug the refrigerator before cleaning and making repairs.
• Do not use a wet or damp cloth when cleaning the plug.
• Remove any foreign matter or dust from the power plug pins.
- Otherwise there is a risk of fire.
• If the refrigerator is disconnected from the power supply, you should wait for at least ten minutes before plugging it
back.
Safety Information