Filter
Top Products
31
INSTALLATION INSTRUCTIONS
INSTALLING THE WATER DISPENSER LINE
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the
water line is not excessively bent, pinched or squashed.
Complete the installation of the water supply line.
- Power on the refrigerator and press the lever on the right of the
dispenser until water runs out through the water line and all air has been empty.
- At this time, check for any possible leakages at the join point in the water line.
After securing the water line, move the refrigerator to the required location.
Once the refrigerator is in position, do not move possibly.
- As shown, separate the sticker in the fefrigerator.
Remove the water filter from the box and put a month indicator
sticker on the filter as shown.
- Write the month you installed the filter on the label.
EX) If the water filter was installed in March, put “MAR”
- Remove the protective cap then position and insert the filter as shown,
- Slowly turn the water filter clockwise 90º to align the indication mark on the
cover, locking the filter in postion. Do not overtighten.
Please check if the indication line aligns with the lock position.
CLIP A
WATER LINE
STICKER
(MONTH INDICATION)
SEPARATION
OF RED CAP
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
COVER FILTER
WATER LINE
CONNECTION NUT
Connect the water line to the refrigerator.
Secure the water line.
Install the water filter.
CAUTION
COMPRESSOR COVER OF
REFRIGERATOR
DA99-00494B (EN)-1.3 9/3/07 10:32 AM Page 31