Filter
Top Products
20_ setting up
INSTALLING THE WATER DISPENSER LINE
Parts for water line Installation
Connecting to the water supply line
Connect the water pipe with coupler and tap.
2. Connect coupler “A” to the tap.
CAUTION
The water line must be connected to the cold
water pipe. If it is connected to the hot water
pipe, it may cause the purifier to malfunction.
screws
connector
WARRANTY INFORMATION
This water line installation is not covered by the
Follow these instructions carefully to minimise the risk of
expensive water damage.
Note:
If the coupler does not fit on the current tap, go
the nearest authorised service dealer and purchase the
right couplers fittings.
SIDE OF
WATER INLET
LINE OUTLET
90 degree
select the location where the purifier is
to install. (Model with the purifier)
- If you wish to reassemble the water inlet
and outlet sides of the purifier during purifier
installation, see the reference illustration.
- Cut the water line attached to the purifier to the
appropriate place after measuring the distance
between the purifier and the cold water tap.
Replacement Instructions
2. Note the Flow direction on the filter.
discontinue use and call your supporting dealer.
INLET SIDE
FLOW DIRECTION
You must also ensure that the cut is square and not at
any sort of angle as this could cause a leak
CAUTION
Locking Clip
Insert Locking Clip After
tube seated
DA99-02028A(HM09')-EN(0.0).indd 20 2009.6.10 5:8:17 PM