Filter
Top Products
27
INSTALLATION INSTRUCTIONS
CHECKING THE WATER DISPENSER LINE (OPTIONAL)
Checking the Parts
NOTE
A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer
recommends using a water supply kit containing copper tubing.
1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm
2
is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm
2
), you should install
a booster pump to compensate for the low pressure.
4) Ensure the water storage tank inside the refrigerator is preperly filled initially. Push the water dis
penser lever until the water runs from the outlet.
Purifier
Sealing tape
Clip A x 8EA
Purifier lock
station
Tightening band
Water line
Purifier
Tapping screw x 12EA
(Interior model)
(Exterior model)
DA99-00494B 4/7/03 2:29 PM Page 27