Filter
Top Products
24
CHECKING THE WATER DISPENSER LINE
1) In order to operate the ice maker properly, water pressure of 20~125 psi(0.138~0.862 Mpa) is
required. In this range, a 6 oz paper cup can be filled in 10 secs.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in area with low water pressure (below 20psi), you should install a boost-
er pump to compensate for the low pressure.
4) Ensure the water storage tank inside the refrigerator is filled. Push the water dispenser
lever until the water runs from the outlet.
- Shut off the main water supply line and turn the
Ice maker to the off position.
- Locate the nearest cold water line.
- Follow the instructions in the ice maker
installation kit.
- After connecting the water supply with water
filter, turn on water supply and flush 4 or more
gallons into a bucket to clear the water filter.
1. Cold Water line.
2. Pipe Clamp.
3. Water Line Installation Kit.
4. Shut Off Valve.
NOTE
A Water line installation kit is available at extra cost from your dealer.
Samsung recommends using a water supply kit containing copper tubing.
Connecting to water supply line
DA68-01606B(0.0)-EN 2/28/07 3:24 PM Page 24