Filter
Top Products
27
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
STICKER
(MONTH INDICATION)
COVER FILTER
(A)
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
Please check that the indication line aligns with the lock position.
Install the water filter.
NOTE
1) Slip the compression nut through the provid-
ed plastic tubing.
2) Tighten the compression nut onto 1/4”
comprression fitting.
Connect the water line to the refrigerator.
Water line must be connected to drinkable water only.
Cut off 1/4 inch of the provided plastic tubing squarely to prevent leaks when reconnect.
Do not overtighten the compression nut.
NOTE
1) As shown, the fixed cap separates from the refrigerator by rotating
it counterclockwise.
Remove the water filter from the box and put a month indicator
sticker on the filter as shown.
2) If the water filter was installed in March, put on the "SEP" sticker.
3) Remove the protective cap then position and insert the
filter as shown.
4) Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in posi
tion. Do not overtighten.
Keep the cap(A) in a safe place for recapping, when you will
not use the filter.
NOTE
NOTE
Using Copper Tubing
- Slip the compression nut and ferrule on cop-
per tubing as shown.
Using Plastic Tubing
- Insert the molded end of the plastic tubing
into the compression fitting.
3) Tighten the compression nut onto the compres-
sion fitting.
4) Turn water on and check for any leakage.
Compression Nut (1/4
(Provided)
Compression Fitting
(Provided)
Compression Nut (1/4
(Purchased)
Plastic Tubing
(Purchased)
Copper Tubing
(Purchased)
Ferrule
(Purchased)
Household Water Line
Refrigerator
SEPARATION
OF RED CAP