Filter
Top Products
39
Circuit Descriptions
10-4) Door S/W Sensing Circuit
10-5) Temperature Sensing Circuit
1) The terminals, ② and ⑥ of the connector (CN30) are grounded, and DC5V (Vcc) is supplied to the terminals, ⑤ and
⑥ through the resistors, R404 and R403 for the freezer and the refrigerator door, respectively.
2) The micro-processor senses the door’s open and close based on engaged voltages, “Low(0V)” and “High(5V),”
respectively.
Note) The door switch always should be checked when the evaporator fan is not running while the door is closed.
Terminal
Operation Volt(state)
Freezer
DOOR CLOSE
DOOR OPEN
0V (LOW)
5V (HIGH)
Ref.
DOOR CLOSE
DOOR OPEN
0V (LOW)
5V (HIGH)
# of t
erminal in MICOM Remark
PIN #49 (F-SENSOR)
PIN #50 (F-DEF-SENSOR)
PIN #52 (R-SENSOR)
PIN #53 (R-DEF-SENSOR)
PIN #56 (EXT-SENSOR)
Micom
terminal
voltage may
change
according to
temp.
1) A thermistor with a negative temperature coefficient (NTC) is used for a temperature sensor.
2) Resistors, R 306 ∼ R310 and capacitors, C 301 ∼ C 305 are used for a noise protection purpose.
3) For the F-sensor, the input voltage into the micro processor (MICOM), VF is calculated by (Rth x Vcc)/(R303+ Rth),
where Rth is a corresponding resistance to the thermistor’s output (See Ref. 6 in Appendix).
4) The F-Def sensor is connected with a bimetal and a temperature sensor is in parallel. In a normal operation of the
system, the bimetal is on and 0V is input into the micro-processor. During a defrost cycle, the bimetal will be off from
54℉, and a divided voltage with R304 enter to the micro-processor to keep sensing the set temperature.