Samsung RS2630** Refrigerator User Manual


 
25
INSTALLATION INSTRUCTIONS
INSTALLATION OF THE WATER DISPENSER LINE
Remove any residual matter inside the water supply line after installing filter.
1) Turn on the main water supply & shut-off valve of the water
supply line.
2) Run water through the dispenser until the water runs clear
(6~7 minutes). This will clean the water supply system and
clear air from the lines.
3) Additional flushing may be required in some households.
4) Open the refrigerator door and check if water leaks around
the water filter.
3) Remove the protective cap, then position and insert the
filter as shown.
4) Slowly turn the water filter clockwise 90º to align
the indication mark on the cover, locking the filter in posi-
tion.
WATER
ICE
A newly-installed water filter cartridge may cause water to briefly spurt from the dispenser.
NOTE
SEPARATION
OF RED CAP
STICKER
(MONTH INDICATION)
COVER FILTER
ALIGN THE INDICATION MARK
WITH LOCK POSITION.
• Please check that the indication line aligns with the lock position.
• If you are replacing the cartridge, first remove the old one by slowly turning it to the left. Do
not pull down on the cartridge. A small amount of water may drip down.
• If your refrigerator does not have a water filter, we recommend installing one if your water
supply has sand or particles that could clog the screen of the refrigerator’s water valve.
Install it in the water line near the refrigerator.
NOTE
DA68-01365A-1.0 5/3/06 9:59 PM Page 25