Filter
Top Products
11
Mechanical Disassembly
The ice dispenser is located in the upper portion of
the freezer. This assembly stores ice made by the
icemaker and dispenses ice.
1. Lift the ice bucket up and slide out the ice
dispenser assembly .
The ice maker is located inside of the ice dispenser
assembly.
1.
Remove ice maker support screws (2), and slide out.
2. Disconnect the ice maker wire connector.
3.
Unlock the locking tabs to separate the ice maker kit.
In order to assemble the icemaker kit.
1. Assemble the geared motor shaft and the front of
ice tray.
2. Lift the front locking tab and assemble the ice
maker kit.
3. Connect the ice maker wire connector.
4. Match the tab holes and tabs(2) located on the
top of the liner, and slide the ice maker in.
5. Tighten the screws (2) of the ice maker support.
This shelf is designed to support the ice maker
ice dispensed and Xtra Space
TM
.
1. Remove the Xtra Space
TM
cover to push it down
and pull front.
2. Slide the partition out.
3. Remove the screws (2) on the bottom front of the
case.
4. Slide out the case while disconnecting the wire
connect.
Auger Motor Case
PARTITION
SCREWS
WIRE CONNECTOR
SUPPORT OF ICE-MAKER
FRONT OF ICE TRAY
FRONT LOCKING TAB
TAB HOLES
GEARED MOTOR SHAFT
ICE-MAKER KIT
LOCKING TAB
Ice Dispenser & Ice Maker