Samsung RS265TD Refrigerator User Manual


 
4_ safety information
SEVERE WARNING SIGNS FOR INSTALLATION
Do not install the refrigerator in a damp place or place where it may come in contact
with water.
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
Do not install this appliance in a humid, oily or dusty location, in a location exposed to
direct sunlight and water (rain drops).
Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room
heaters or other appliance.
Do not plug several appliances into the same multiple power board. The refrigerator
should always be plugged into its own individual electrical board which has a voltage
rating that matched the rating plate.
- This provides the best performance and also prevents overloading house wiring circuits,
which could cause a fire hazard from overheated wires.
• If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
Do not use a cord that shows cracks or abrasion damage along its length or at either end.
• Do not bend the power cord excessively or place heavy articles on it.
Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and
pull straight out from the outlet.
- Damage to the cord may cause short-circuit, fire and/or electric shock.
• Do not use aerosols near the refrigerator.
- Aerosols used near the refrigerator may cause an explosion or fire.
The water supply to this refrigerator must only be installed/connected by a suitably
qualified person and connect to a potable water supply only.
In order to operate the ice maker properly, water pressure of 20~125 psi is required.
WARNING
safety Information
• The Refrigerator must be safely grounded
- Always make sure that you have grounded the Refrigerator before attempting to investigate
or repair any part of the appliance. Power leakages can cause severe electric shock.
This refrigerator must be properly installed and located in accordance with the manual
before it is used.
• Connect the power plug in proper position with the cord hanging down.
- If you connect the power plug upside down, the wire can get cut off and cause a fire or
electric shock.
When moving the refrigerator, be careful not to roll over or damage the power cord.
- This constitutes a fire hazard.
Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
• Keep the packing materials out of reach of children.
- There is a risk of death from suffocation if children put them on their head.
The appliance must be positioned so that the plug is accessible after installation.
You need to remove all the protective plastic film before you initially plug in to use the
product.