Filter
Top Products
setting up _19
Remove any residual matter inside the filter. (Model with the filter)
- Open the main water tap to check whether
water is running through the water tube on
the water inlet side of the filter.
- If water does not come out through the line,
check whether the tap is open.
- Leave the tap open until clean water is
running out and any residual matter that built
up during manufacturing has been removed.
Attach the filter lock stations.
- Hold the filter lock stations in the appropriate
position (under the sink for example) and fix it tightly
into place where to screw.
Secure the filter in position.
- Fix the filter in position, as shown in the
figure on the right.
setting up your side-by-side
refrigerator
01 SETTING UP
Select the location where the filter is to
install. (Model with the filter)
- If you wish to reassemble the water inlet and out
-
let sides of the filter during filter installation,
see the reference illustration.
- Cut the water line attached to the filter to the
appropriate place after measuring the distance
between the filter and the cold water tap.
COUPLER
SIDE OF
FILTER
WATER INLET
SIDE OF FILTER
LINE OUTLET
90 degree
FILTER WATER
REFERENCE
WATER LINE
FILTER
WATER
OUTLET SIDE
OF FILTER
TWO FILTER LOCK
STATION
TWO FILTER LOCK
STATION
TIGHTENING
BAND
FILTER
WATER TUBE
FILTER
LOCK
STATIONS