Filter
Top Products
28
CHECKING THE WATER DISPENSER LINE (OPTIONAL)
INSTALLING OF THE WATER DISPENSER LINE
Checking the Parts
1) In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm
2
(0.14 ~ 9.8Mpa,
19.9 ~ 142.2 psi, 1.37 ~ 9.8 bars) is required.
In this range a 100 cc paper cup can be filled in 10 seconds.
2) The water filter removes particles. It does not sterilize or destroy any micro-organisms.
3) If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm
2
, 0.14 Mpa,
19.9 psi,1.37bars), you should install a booster pump to compensate for the low pressure.
4) Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis
penser lever until the water runs from the outlet.
Connecting to water supply line
- Shut off the main water supply line and turn the Ice
maker to the off position.
- Locate the nearest cold drinking water line.
- Follow the instructions in the ice maker installation kit.
(Case 1)
1. Cold Water line
2. Pipe Clamp.
3.Copper (or Plastic) line
4.Compression Nut
5.Compression Sleeve
6.Shut Off Valve
7.Packing Nut.
NOTE
A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer
recommends using a water supply kit containing copper tubing.
Purifier Valve water fitting
Clip A x 12EA
Water line
Tapping screw x 12EA
(Connector Water Filter Assy)
Sealing tape
Epel pjt IB-01453B-EN (0.1) 4/15/05 1:17 PM Page 28