Filter
Top Products
USING THE DIGITAL DISPLAY
“ Freezer Temp.” indicates the current Freezer temperature.
“ Fridge Temp.” indicates the current Fridge temperature.
When not in use the Display will turn off, this is normal.
Power Freeze
This icon will light up when you activate the “Power Freeze” feature. “Power Freeze” is great for times
when you need a lot of ice. When you have enough, just press the button again to cancel the “Power
Freeze” mode.
When you use this function the energy consumption of the refrigerator will increase. Remember
to turn it off when you don’t need it and return the freezer to your original temperature setting.
Energy Saver
This icon will light up when you activate the “Energy Saver” function. The Energy Saver function is
automatically set to “ON” when power is supplied to the Refrigerator. If condensation occurs on the
doors, turn the Energy Saver function off.
Alarm
This icon will be lit all the time. The door alarm will sound if any door is open for more than 2 minutes.
The beeping stops when you close the door. If you need to turn off the Alarm function, press the
Lighting and Fridge buttons for 3 seconds at the same time.
Lighting
This icon will light up when you activate the “Lighting” feature. In this case, the dispenser light (under
the display) will be on constantly. If you would like the dispenser light to come on only when using the
dispenser, turn the “Lighting” feature off by pressing the “Lighting” button..
Power Cool
This icon will light up when you activate the “Power Cool” feature(refer to 5. Fridge Button on Page
18 to select this function). For a quick fridge cool down, use “Power Cool”. If you select “Power
Cool”, the inside temperature of the Fridge will decrease for about two and a half hours.
Filter Indicator
When the filter indicator light changed to red, it is time to change the filter. Typically this happens
about every 6 months.
The filter Indicator will be Blue when you initially insert the water filter.
The filter Indicator will be purple when you have used your water filter for 5 months.
The filter Indicator will be Red when you have used your water filter for 6 months.
After removing the old water filter and installing a new one (see page 29 for instructions on how to do
this), reset the indicator status light by pressing the Ice off button for about 3 seconds.
Cubed Ice , Crushed Ice
Enjoy cubed or crushed ice by selecting your preference from the digital control panel. The ice type
light indicates the type of ice that is currently chosen.
Water
This icon will light up when you activate the “Water” feature.
Operating _19
02 OPERATING
DA99-01746B(EN-1)-GGH.indd 19 2008.7.24 2:52:41 PM