Filter
Top Products
setting up _17
4. Remove the fi lter cap and insert the fi lter
into the fi lter housing.
5. Slowly turn the water fi lter 90º clockwise
to align with the printing mark on the
cover, locking the fi lter in position. Make
sure to align the water fi lter label mark
with center of cover fi lter printing as
illustrated. Remember, do not over-
tighten.
Removing any residual matter inside the water
supply line after installing fi lter.
1. Turn ON the main water supply.
2. Press the Water button and push the dispenser pad.
3. Run water through the dispenser until the water runs clear (approx.
3L). This will clean the water supply system and remove air from the
lines.
4. Additional fl ushing may be required in some households.
5. Open the refrigerator door and make sure there are no water leaks
coming from the water fi lter.
A newly installed water fi lter cartridge may cause water to briefl y
spurt from the water dispenser. This is due to air getting into the
line. It should pose no problem to operation.
01 SETTING UP
Cover fi lter
Align the indication
mark with lock position
Separation
of red cap
45
Water
Ice