Filter
Top Products
setting up
_07
01 SETTING UP
SETTING UP THE REFRIGERATOR
DOORS
If your entrance won’t allow the refrigerator to pass
easily through it, you can remove the doors.
Separating the Water Supply Line from the
Refrigerator
1. Pull the two water lines (which are in the Fixer) out
to the front.
2. Remove two water lines (White one is for water
and the other one is for ice) by pressing the
coupler
1
and pulling the water line
2
away.
Removing the freezer door
A few things to mention fi rst.
• Make sure that you lift the door straight up so the
hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire
harness on the door.
• Place doors on a protected surface to prevent
scratching or damage.
1. Remove a screw on the upper hinge cover
1
.
With the door open, disengage the two locking
tabs with a fl at-head screw driver
2
and remove
it while the lifting up the rear of the cover
3
, and
then disconnect the wires by gently pulling them
apart
4
.
2. Removing the FIXER HINGE ,and next take off the
upper hinge. Be careful that the door does not fall
on you as you are removing it.
Be sure to keep track of all parts you are
removing.
3. Next, remove the door from the lower hinge
5
by
carefully lifting the door straight up
6
.
Be careful not to pinch the water tubing and
wire harness on the door.
Reattaching the freezer doors
To reattach the freezer doors, replace parts in reverse
order
Reattaching the Water Supply Line
1. The Water Line must be fully Inserted to the center
of transparent coupler to prevent water leakage
from the dispenser.
2. Insert the 2 clips in the install pack and check that
each clip holds the line fi rmly.
Do not cut the water line. Gently separate it
from the coupler.
1
2
Make sure the color of
Make sure the color of
the water lines match.
the water lines match.
6
5
Center of transparent coupler
Center of transparent coupler
clip A (¼”)
clip A (¼”)
(6.35mm)
(6.35mm)
4
3
2
1