Filter
Top Products
setting up _11
01 SETTING UP
3
4
5
2
1
setting up your side-by-side
refrigerator
2. Removing the freezer door
A few things to mention first.
• Make sure that you lift the door straight up so the hinges are not bent or broken.
• Be careful not to pinch the water tubing and wire harness on the door.
• Place doors on a protected surface to prevent scratching or damage.
1. With the Freezer door closed, remove the upper hinge cover
1
using a screwdriver, and then
disconnect the wires by gently pulling them apart
2
.
7
6
Be careful not to pinch
the water tubing and
wire harness on the
door.
2. Remove hinge screws
3
and the ground screw
4
by turning counter-clockwise, and take off
the upper hinge
5
. Be careful that the door does not fall on you as you are removing it
3. Next, remove the door from the lower hinge
6
by carefully lifting the door straight up
7
.
4. Remove the lower hinge
8
using a hex wrench.
DA99-01584A(HM-P)-EN(0.1).indd 11 2007.10.4 5:20:27 PM