Filter
Top Products
01 SETTING UP
setting up your side-by-side
refrigerator
Remove any residual matter inside the purifier. (Model with the purifier)
- Open the main water tap to check whether water
is running through the water tube on the water inlet
side of the purifier.
- If water does not come out through the line, check
whether the tap is open.
- Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
setting up _21
WATER LINE
PURIFIER
WATER
OUTLET SIDE
OF PURIFIER
Secure the water line.
- Using clip ”A”, fix the water line to the wall (the back of refrigerator).
- When the water line is secure, make sure whether the water line is not
excessively bent, pinched or squashed.
CLIP A
WATER LINE
Connect the water line to the refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
INSTRUCTIONS
COMPRESSOR COVER OF
REFRIGERATOR
CONNECTION NUT
Attach the purifier lock-clip.
- Hold the purifier lock-clip in the appropriate position
(under the sink for example) and fix it tightly into place
where to screw.
PURIFIER LOCK-CLIP
Secure the purifier in position.
- Fix the purifier in position, as shown in the figure on the right.
WATER TUBE
PURIFIER LOCK-CLIP
PURIFIER
DA99-01584A(HM-P)-EN(0.1).indd 21 2007.10.4 5:20:43 PM