Filter
Top Products
INSTALLATION
CONNECTING TO THE MAINS
Before you use your oven, check that the
voltage shown on the face of the oven
conforms with your mains supply. The mains
lead has a 13 amp plug containing a 13 amp
fuse. If the fuse requires replacing at any time,
the fuse cover should be removed using a
small screwdriver to lever it out. The old fuse
should be replaced by a 13 amp fuse and the
fuse cover must be refitted before the plug is
used again.
If the plug supplied on the mains lead is not
suitable for the socket in your home, it should
be cut off and disposed of safely, or
destroyed, to avoid possible shock hazard
resulting from the plug being inserted into a
13 amp socket).
If the fuse cover is lost or damaged, the plug
must not be used until a replacement is
obtained. Replacement fuse covers are
available from SANYO SERVICE CENTRES.
It is important that the colour of the
replacement fuse cover corresponds with the
coloured insert or as embossed in words on
the base of the plug.
WARNING – THIS APPLIANCE MUST BE
EARTHED
IMPORTANT:
The wires in this mains lead are
coloured in accordance with the following code:
Green-and-yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire, which is coloured green-and-yellow,
must be connected to the terminal in the plug,
which is marked with the letter E or by the
earth symbol or coloured green or
green-and-yellow. The wire, which is coloured
blue, must be connected to the terminal,
which is marked with the letter N or coloured
black. The wire, which is coloured brown,
must be connected to the terminal, which is
marked with the letter L or colour red.
It is recommended that a separate circuit
serving only the oven be provided. Using a
high voltage is dangerous and may result in a
fire or other accident causing oven damage.
Note:
1. If you have any questions about grounding
or electrical instructions, please consult a
qualified electrician or service person.
2. Neither the manufacturer nor the dealer can
accept any liability for damage to the oven or
personal injury resulting from a failure to
observe the electrical connection procedure.
6