Sanyo EMS-8500S Microwave Oven User Manual


 
13
CLEANING AND CARE
When cleaning surfaces of door and door
jamb, use only mild, nonabrasive soap or
detergents applied with a sponge or soft
cloth.
Turn off the oven and remove the power
plug from the wall socket before cleaning.
Keep the inside of the oven clean. When
food splatters or spilled liquids adhere to
oven walls, wipe with a damp cloth. Mild
detergent may be used if the oven gets very
dirty. Avoid the use of spray and other harsh
cleaners as they may stain, streak or dull the
door surface.
The outside surfaces should be cleaned with
a damp cloth. To prevent damage to the
operating parts inside the oven, water
should not be allowed to seep into the
ventilation openings.
Wipe the window on both sides with a damp
cloth to remove any spills or spatters.
Do not allow the control panel to become
wet. Clean with a soft, damp cloth. When
cleaning the control panel, leave oven door
open to prevent oven from accidentally
turning on.
If steam accumulates inside or around the
outside of the oven door, wipe with a soft
cloth. This may occur when the microwave
oven is operated under high humidity
conditions, this is normal.
It is occasionally necessary to remove the
glass tray for cleaning. Wash the tray in
warm sudsy water or in a dishwasher.
The roller ring and oven floor should be
cleaned regularly to avoid excessive noise.
Simply wipe the bottom surface of the oven
with mild detergent. The roller ring may be
washed in mild sudsy water or dishwasher.
When removing the roller ring from cavity
floor for cleaning, be sure to replace in the
proper position.
Remove odors from your oven by combining
a cup of water with the juice and skin of one
lemon in a deep bowl, microwave for 5
minutes. Wipe thoroughly and dry with a soft
cloth.
When it becomes necessary to replace the
oven light, please consult a dealer to have it
replaced.
SAVE THESE INSTRUCTIONS