Filter
Top Products
23
ROUTINE MAINTENANCE
WARNING
Always disconnect the power supply to the unit prior to any repair or maintenance of the unit in
order to prevent electric shock or injury.
Ensure you do not inhale or consume medication or aerosols from around the unit at the time of
maintenance. These may be harmful to your health.
Cleaning
1. Clean the unit once a month. Regular cleaning keeps the unit looking new.
2. Use a dry cloth to wipe off small amounts of dirt on the outside and inside of the unit and all
accessories. If the outside panels are dirty, clean them with a diluted neutral dishwashing detergent..
(Undiluted detergent can damage the plastic components. For the dilution, refer to the instruction of the
detergent.)
3. After the cleaning with the diluted, always wipe it off with a wet cloth. Then wipe off the cabinet or
accessories with a dry cloth.
4. Never pour water onto or into the unit. Doing so can damage the electric insulation and cause failure.
5. The compressor and other mechanical part are completely sealed. This unit requires absolutely no
lubrication.
￭ There is a fan behind the compressor, so be very careful if you stick your hand into this part of the unit.
Cleaning of condenser filter
This unit is provided with the filter check lamp. This lamp flickers and the buzzer sounds when the
condenser filter is clogged. Clean the filter according to the following procedure. As a clogged filter
may cause poor cooling and compressor trouble, clean it once a month.
1. The filter fitted to the grille can be removed as shown in
the figure.
2. Remove the mounting screw securing the grille and pull
out the grille.
3. Remove the filter installed inside the grille, wash it with
water and dry it naturally.
4. Replace the clean filter as before.
5. Replace the grille and tighten the screw and check that
the filter check lamp is off.
Defrosting of inside wall
Defrost the inside wall of the freezer as follows:
Normal defrosting
Remove the frost by the enclosed scraper. Take care not to damage the inside wall.
Thorough defrosting
1. Take out and transfer all the contents to another freezer or container which contains liquid CO
2
, liquid
N
2
, or dry ice. Switch off the alarm and back-up system of AT type. Switch off the power supply.
2. Open the door and remove the inner lid. Leave the freezer as it is. The water remaining in the
freezer compartment should be wiped up.
3. After cleaning is completed, restart the operation according to the procedure. Put back the articles
into the sufficiently cooled freezer compartment.