13. Remove water distributors from ice machine.
Inspect distributor for restricted orifice holes.
Be sure all holes are full open.
14.
Locate ice thickness sensor. Squeeze
mounting legs together to release sensor.
Wash the metal surfaces of the sensor and the
adjustment screw with ice machine scale
remover solution. Also wash the water
distributor and curtain with the ice machine
scale remover solution.
15. Locate water level sensor. Squeeze catches
together and pull up to remove sensor. Wash
metal surfaces of sensor with ice machine
scale remover solution.
16. Mix a solution of sanitizer.
Note: A possible sanitizing solution may be made
by mixing 1 ounce of liquid household bleach with 2
gallons of warm (95-115
o
F.) potable water.
17. Thoroughly wash all surfaces of the ice
thickness sensor, water level sensor, curtain
and water distributor with the sanitizer solution.
18. Wash all interior surfaces of the freezing
compartment, including evaporator cover and
right side panel liner with the sanitizer solution.
19. Return water level sensor, ice thickness
sensor, water distributors and curtains to their
normal positions.
20. Push and hold the clean button to drain the
reservoir. Push and release the clean button
again and when the purge valve indicator light
goes out, immediately pour the remaining
cleaning solution into the reservoir.
21. Circulate the sanitizer solution for 10 minutes,
then push and release the Clean button.
22. Allow the water system to be flushed of
sanitizer for at least 20 minutes, then push and
release the Off button.
23. Return the evaporator cover and front panel to
their normal position and secure with the
original fasteners.
24. Push and release the On button to resume ice
making.
Ice Storage Bin
1. Remove and discard all ice.
2. Mix a solution of 7 ounces Scotsman Clear 1
ice machine scale remover to 84 ounces of
potable water and wash all interior surfaces of
the ice storage bin to remove any mineral scale
build up. Pour excess cleaner solution into the
bin’s drain.
3. Mix a solution of sanitizer and thoroughly wash
all interior surfaces of the ice storage bin. Pour
excess sanitizer solution into the bin’s drain.
July 2006
Page 22
C0522 through C1030
Remote Condenser Models - User Manual
Remove Water Distributor
Squeeze Tabs Together, Slide Out Until it Stops,
Then Lift to Remove
Inspect Orifice Holes
Inspect Water Distributor