![](http://pdfasset.owneriq.net/0/8f/08f9de15-85d3-4af4-b97b-2c371672b380/08f9de15-85d3-4af4-b97b-2c371672b380-bg4.png)
FOR THE INSTALLER
Location
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
above and behind it for service. Air cooled models
require a minimum of 6 inches to the left and right
of the machine for air circulation.
Machine Stand Installation
Tip the stand on its back and install the legs, return
the stand to the upright position. Adjust leg levelers
so that the stand does not “rock”.
Counter Top or Machine Stand Installation
The base of the icemaker-dispenser must be
sealed to the object it rests upon. Food grade
silastic sealant such as Scotsman part number
19-0529-01 is recommended.
Place a bead of the sealant on the machine stand
or counter top to match the outside edge of the
cabinet base and sink.
The icemaker-dispenser is heavy: use of a
mechanical hoist is recommended to lift it to the
height required to install it.
The DMS machine stand has holes in the top that
match up with threaded holes in the
icemaker-dispenser. Place the cabinet onto the
machine stand, so that the unit is lined up with the
holes. Secure the ice maker-dispenser to the
machine stand with bolts and washers.
In both counter top and machine stand
installations, wipe off and neatly smooth any
excess sealant. Level the machine stand and
cabinet.
Unpack and install the sink brackets. Fit the sink
assembly onto the two sink brackets, and press
onto the bead of sealant. Wipe off and neatly
smooth any excess sealant from under the sink
edge.
Unpack and install the ice and water spouts.
Ice Spout: Slide up and over ice outlet. No
fastener is required to hold it in place.
Water Spout: Slide over stainless steel water
discharge tube, locate and match up with notches
in the base. Rotate clockwise to move spout into
installed position.
MDT5N25 & MDT5N40
May 2001
Page 4
SEAL THE
UNIT TO
THE
COUNTER
OR STAND
Water
Spout
Ice Spout