Filter
Top Products
How to remove scale from the ice making system.
Cleaning this machine involves adding a solution of
scale remover and water to the ice machine and
continuing to add it as it makes ice. The scale
remover must be diluted to the correct ratio. A
squirt bottle will make adding the scale remover
much easier when the unit is built in. If not built in,
remove the top panel for reservoir access.
Recommended tools: Rubber gloves, squirt bottle
& scale remover. Pre-Mixed 16 oz squirt bottle of
scale remover is part number 19-0664-01.
1. Scoop out and discard all of the ice.
2. Press and release the On/Off button.
3. Open door and locate screws at upper back wall
of bin. Remove the two screws.
4. Remove the back wall of the bin by lowering it
down past the scoop holder, feel free to rotate the
scoop holder loop down to make more room.
5. Push tab on front edge of reservoir cover and
remove the cover. Note: Adjacent wires are low
voltage and are not hazardous.
May 2011
Page 14
SCN60
Installation and Use
Ice
Making
Check
Water
Time to
Clean
Clean
Reset
Screws
Float Valve
On/Off Lever
Reservoir Cover
Release Tab
Push In Tab to Release Cover
Lift Reservoir Cover to Remove
Ice
Making
Check
Wate r
Time to
Clean
Clean
Reset