Filter
Top Products
7
OPTIONAL REMOTE THERMOSTAT OPERATION
Attach the sensing bulb with the bulb clip to one
of the lower mounting screws on the plate. The
sensing bulb must be in excellent thermal contact
with the plate. We recommend that the probe be
mounted on the plate in one of the lower mounting
positions as shown in the drawing below. This is
best because these positions remain colder.
The SEA FROST BD thermostat is variable. Turning the knob fully counterclockwise
turns the unit "OFF". The fully clockwise setting is the coldest (three snowflakes). The
thermostat may be adjusted to obtain any temperature desired in the cabinet. The
thermostat may be calibrated should the warmest setting be too cold. To calibrate the
thermostat remove the mounting screws and tip the panel forward. Remove the
electrical tape to expose a black #7 torx adjustment screw about an inch into the case.