Sears 233.52153 Ventilation Hood User Manual


 
WIRING CONNECTIONS
All wiring connections must comply with local codes and the unit
must be properly grounded.
1. Make sure box connector is secure.
2. Refer to FIGURE 8. Make wiring connections.
3. Replace electrical box cover and secure with screw.
LAMP INSTALLING
OR REPLACEMENT
1. Depress sides of light diffuser until tabs of diShlser disengage from
slots in hood. Remove diffuser.
2. Install (2) 40 watt maximum,Type A-15 appliance bulbs.
3. Replace difuser in hood by depressing sides and engaging tabs in
slots in hood.
FILTER INSTALLATION
AND REPLACEMENT
1. For ducted operation, install the aluminum mesh filter. For non-
duct operation, install the non-ducted filter (Model 50190, sold
separately).
2. Refer to FIGURE 9. The filter slides into channels at the back of
the hood,on either side of the fan compartment,and snaps under
the spring clips near the front of the fan compartment.
MAINTENANCE
FILTERS
IMPORTANT:The aluminum filter should be removed once monthly
and washed in hot detergent water. Rinse in clear, warm water and
shake off excess moisture before replacing. The fdter may also be
cleaned in your dishwasher.
INA NON-DUCTED INSTALLATION:Replace filter every 3_ months
as needed.
CLEANING
The hood should be wiped off occasionally both inside and outside
using warm water, mild dish detergent and a soft cloth. Never use
scouring powders, steel wool pads or any other abrasive cleaners
which will destroy the hood's finish.
O
WHT
BLK
O
O
0'J
' i WHT
. BLK
:GREEN_ROUND:
:SCREW : GREEN
: _-"_OR BARE
.............. : (GROUND) O
FIGURE8
FIGURE 9
5