Filter
Top Products
REMOVABLE OVEN DOOR
The oven door can be removed for cleaning.
TO removo:
1. Open the door to the broil stop position (see
Illustration).
2. Grasp the door at each side and lift up and off the
hinges.
NOTE: When the door is removed and hinge arms
are at stop position, do not bump or try to move
the hinge arms. The hinges could snap back
causing an injury to the hands or damage to the
porcelain on the front of the oven. Cover the
hinges with toweling or empty towel rolls while
working in the oven area.
To replace:
1. Hold the door over the hinges with the slots st the
bottom edge of the door lined up with the hinges. The STOPPOSITION
hinge arms must still be In the stop position.
2. Slide the door down onto the hinges as far as Itwill go
and close the door.
STOP (BROIL) POSITION
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when
installing or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bIt and push the
rack all the way In.
To remove:
1. Pull the oven rack out, then up.
BUMPIN
RACK
Note:
The racks are designed with stop locks. When
the racks are placed correctly on the rack sup-
port and extended from the oven the stop locks
prevent the racks trom tilting when removing
foods from them or placing fends on them.
LIFT-UP COOKTOP
TO raise the cooktop so the ares underneath can be
cleaned, grasp the cooktop at the front and lift up.
The range has a support to hold the cooktop while
cleaning. Raise the support as shown in the lUustratlon.
Porcelain enamel can chip if dropped. Handle
porcelain enameled €ooktops carefully.
11 NEMNTT0-1