Filter
Top Products
REMOVABLE OVEN DOOR
To remove:
1. Open the door to the stop position (see Illustration).
2. Grasp the door at each side and lift up and off the
hinges.
NOTE: When the door is removed and hinge arms
are at stop position, do not bump or try to move
the hinge arms. The hinges could snap back
causing an injury to the hands or damage to the
porcelain on the front of the range. Cover the
hinges with toweling or empty towel rolls while
working in the oven area.
To replace:
t. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The hinge arms must still he in the stop
position.
2. Slide the door down onto the hinges as far as It will
go and close the door.
STOP POSITION
HINGE
VENTTRIM
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when Installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides,
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way In.
TO remove:
1. Pull the oven rack out, then up, In one motion. See
the cleaning chart.
Note: For best performance remove oven racks
during a clean cycle. If oven racks are left
in the range during a clean cycle, they will
darken, lose their luster and become hard
to slide. If you choose to leave the racks
in the oven, you can polish the edges of
the racks with steel wool and apply a
small amount of vegetable oil to the rack
edges after the self-clean cycle. This will
make the racks easier to slide.
16 NEMNT71