Sears 71061 Range User Manual


 
Questions? Before You Call for Service...
PROBLEM POSSIBLE CAUSE
TOP BURNERS DO NOT
LIGHT OR DO NOT
BURN EVENLY
Make sure electrical plug is plugged into a live power outlet.
Burner holes on the side or around the top of burner may be clogged.
Remove burners (on models with standard twin burners) or burner heads
(on models with sealed burners) or burner caps on spill-proof models, and
clean them with a sewing needle or twist-tie. Make sure you do not enlarge
the holes. On spill-proof models, check electrode area for burned-on food or grease.
•Make sure the drip pans are installed correctly
BURNER FLAMES VERY tf range is connected to LP gas, contact the person who installed your range
LARGE OR YELLOW t or made the Conversion.
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
Pilot(s) is (are)not lit (on standing pilot models). See the Lighting
Instructions for Standing Pilot Models section in Surface Cooking.
The oven gas Shut-offvalve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-offvalve on standard twin burner models, raise the
cooktop arid !ook for the gas shut-offlever at the extreme right rear corner.
Follow the directions in boxA or B that match your regulator type.
shown closed/
Standard Twin Burner Models
[ \B
I Lever shown closed /
Standard Twin Burner Models
_Ib check the oven gas shUt-off valve on sealed burner models, remove
the storage drawer, broiler drawer or kick panel and look for the gas shut-
off lever at the back of the range.
-<<........ f2
g '
Sealed Burner Models
4O